3CVAPE X VAPE GEEK Q8 SAHARA 24MM BF RDA
The 3CVape & Vape Geek Q8 Sahara 24mm RDA is a rebuildable dripping atomizer that is a powerhouse, featuring an unique gold-plated build deck with W-shaped 2mm terminals, paired with a locking airflow section. The Sahara RDA's entire build deck and terminal posts are plated in gold for superior conductivity and style points, while the 2mm terminals can accommodate a myriad of hand-built and pre-made coils available on the market or created by hand. In addition, the W-Shaped terminal posts are raised and suspend the coils from above. The cotton leads are draped into the 4mm deep juice well allowing for any squonk eLiquid to pool and accumulate for immediate vaping. The Sahara RDA uses a locking inner barrel, double sealed with O-Rings, which hosts the airflow system for this RDA sporting four 2mm air holes on each side for an adjustable vaping experience.
3CVape & Vape Geek Q8 Sahara 24mm RDA Features:
- 24mm Diameter
- 4mm Deep Juice Wells
- Superior 304 Stainless Steel Construction
- U-Shaped Two-Post Build Deck
- Side Secured via Phillips Screws
- Single or Dual Coil Configuration
- Dedicated Airflow Tank Section - Acrylic or ULTEM
- Four (4) Downward Sloping Fully Closeable Air Holes Per Side - 2mm per Hole
- Double O-Ring Internally Locked & Sealed Tank
- 810 Widebore Resin Drip Tip
- Gold-Plated BF Squonk Pin
- Gold-Plated 510 Connection
- Available in Black or Silver
Includes:
- 1 Sahara 24mm BF RDA
- 1 810 Wide Bore Resin Drip Tip
- 1 Spare Parts Pack
- 1 Gold-Plated Bottom Feed Pin
- 1 Flathead Screwdriver
Note: When it comes to using RDA, RTA, and RDTA, we strongly recommended to wash and clean all the atomizers thoroughly and carefully. Likewise, please have a great sense of knowledge when it comes to handling and using these products.
We always strongly recommend testing the coils with ohm-meter before using them with your mods, devices and batteries. Coils with low resistance are not suitable with all mods, devices and batteries. Please make sure that your mods, devices and batteries can handle low resistance before using them.
